PACKA-Screws - White Housing WH10 and Other Slimline Housings

PACKA is a pack of mounting screws sized for the WH10 white housing bracket and other slimline housing brackets of the same format. WrekinWater sells it separately so a missing or stripped screw doesn't stop a straightforward bracket fitting job. It covers the fixing points on a standard slimline housing bracket, ready to mount straight to a wall.

Why you might need this

• The original screws have been lost or misplaced during installation.
• You're missing hardware after moving or reinstalling your housing.
• A screw has stripped or rounded off and needs replacing.
• You're fitting a WH10 or similar slimline bracket for the first time and need the correct fixings.

A slimline housing bracket needs screws that match its fixing points and are strong enough to hold a full housing steady on the wall. Using whatever's left in a toolbox drawer risks screws that are too short, too long, or the wrong thread for the bracket's holes, which can leave the housing loose or, in the worst case, pull free from the wall. This pack is sized specifically for WH10 and equivalent slimline brackets, so the fit is right from the first fixing.

WrekinWater is a family run company based in Bettisfield, Shropshire, with more than 50,000 customers served over 15 years and an "Excellent" rating on Trustpilot. We stock the small fixings that go with our housings, not just the housings themselves, so a straightforward job doesn't get held up over a missing screw.

How to fit it

1. Position the housing bracket on the wall where you want to mount it.
2. Mark the fixing points through the bracket's screw holes.
3. Drill pilot holes suited to your wall type if needed.
4. Fix the bracket in place using the screws from this pack.
5. Check the bracket is secure and level before hanging the housing.
6. Fit the housing and confirm it sits firmly without movement.